Allied Telesis FORMULA 8200 - Manual (Page 157)

FORMULA 8200 User’s Guide
C-11
6. Enter c to change the parameters for downloading the image
software:
7. Respond to each prompt, beginning with boot device, basing
your entries on Table C-3.
8. Select Transfer, then Send File.
9. When prompted, browse for the firmware and select
communications protocol Zmodem. Make sure the firmware file is
named
firmware .
10. Press the SEND button.
The process takes about 25 minutes.
11. Reset the FORMULA 8200.
When the system starts, the following message appears:
[VxWorks Boot]: c
‘.’=clear field; ‘-’=go to previous field; ^D=quit
boot device:
Table C-3 Parameters for Downloading the Image Software
System Prompt User Entry
boot device: flash
processor number: 0
host name: Press [Return]
file name: /flash/firmware
inet on Ethernet (e) : Press [Return]
host inet (h) : Press [Return]
gateway inet (g) : Press [Return]
user (u) : Press [Return]
ftp password (pw) (blank = use rsh): Press [Return]
flags (f) : 0x4
target name (tn) : Press [Return]
startup script (s) : Press [Return]
other (o) : Press [Return]
Press any key to stop auto-boot...