Allied Telesis FORMULA 8200 - Manual (Page 67)

FORMULA 8200 User’s Guide
4-21
Repeat the procedure to upload AGENT.CNF to a
corresponding pre-existing file (for example, agent.001 ) in
the server.
You are done backing up your files. You may proceed with the
software upgrade.
Configuring for
the Download
Process
To configure the FORMULA 8200 for the TFTP download
process:
The following steps provide the FORMULA 8200 with the IP
address of your TFTP server:
1. Log in to the switch and enter:
/TFTP/SERVER
2. Enter the IP address of your TFTP server.
Enter Y in the Save the configuration to flash?
(y/n) prompt to save the TFTP server configuration for later
use.
3. Verify that you can PING the TFTP server from the
FORMULA 8200.
You are now ready to download software to your
FORMULA 8200 switch.
Caution
There is only enough space on the switch to store one version of
software. Do not attempt to download multiple versions on the
switch.
/>tftp/upload/cfg
Name of file on switch ( ) : system.cur
Name of file on tftp server ( ) : system.001
File “/flash/system.cur” on switch to be copied to server “192.48.127.124” as
“system.001”
Are they correct? (y/n) y
Save TFTP configuration to flash? (y/n) n
LF = /flash/system.cur, RF = system.001, SRV = 192.48.127.124, op = put
/TFTP/UPLOAD>
/TFTP/SERVER
IP address of the tftp server () : 192.5.5.18
Save the configuration to flash? (y/n) Y
Writing new configuration to flash ...
Updating system/VLAN configuration....