Allied Telesis FORMULA 8200 - Manual (Page 124)

Command Reference
5-46
VBRIDGE/CONFIG/PARAPORT Example
To disable Spanning Tree for a port (for example, VLAN 1,
port 10):
1. Use the VBRIDGE/CONFIG/PARAPORT 1 command.
A similar display appears:
2. Enter the following at the prompt:
10c = n
Table 5-18 describes the parameters used in the display.
/VBRIDGE/CONFIG >paraport 1
Spanning Tree Port Parameters Modification for VLAN 1:
------------------------------------------------------------------------------
Modification instruction :
usage: =
where option=a(priority), =b(cost),
=c(enable spanning tree), =d(manual mode)
command example:10b= 5 to set the cost for port 10 to 5
------------------------------------------------------------------------------
Enter selection (modification or 0 to commit, c to cancel ) >
Port
Number
------ Port
Priority(a)
----------- Path
Cost(b)
------- Enable
Spanning
Tree(c)
----------- Manual
Mode(d)
-------
1 128 10 y s
2 128 10 y s
3 128 10 y s
.
.
.
16 128 10 y s