Videotec ULISSE PLUS - Manual (Page 38)

EN - English - I
nstruc
tions manual
36
9.6.9 Default menu
01. Delete Setup: Resets all the parameters except
the Presets.
02. Delete Preset: Deletes all previously stored
presets.
DEFAULT
------------------------
1>DELETE SETUP?
2 DELETE PRESET?
Fig. 81
h The above mentioned operations cause the
loss of all previously stored data (i.g. Preset,
Patrol, Autopan, Home…).
9.6.10 Info Menu
The menu is used to check the configuration of the
device and the installed firmware version.
INFO
------------------------
Device ID: 00001
Type : Rs485 only Rx
Baud Rate: 38400-8N1
Protocol : MACRO
Net Board: Fw05.07 Hw01
Mpp Board: Fw05.07 Hw00
Config. : 001
P.C. : UPT1SVSA000E
S.N. : 000000000000
Upgrade : NET BOARD
Fig. 82
9.6.8.2 Washer Menu
The P&T offers the possibility to use a wiper and to
operate a pump to clean the glass.
To configure the Washer put the lens of the camera in
front of the nozzle of the Washer.
Save a preset (XY) that identifies this position; the
preset will be recalled by the pan & tilt when the
WASHER function is enabled.
From the menu, set the following parameters:
01. Enable: Enables the Washer function.
02. Nozzle preset: Enter the preset number (XY)
corresponding to the nozzle.
03. Wiper On Delay: Sets the interval between the
enabling of the pump and that of the wiper.
04. Washing length: Sets the length of the
brushing.
05. Wiper Off Delay: Sets the length of the
brushing without water.
WASHER
------------------------
1 ENABLE : N
2 NOZZLE PRESET : 1
3 WIPER-ON DELAY : 5
4 WASHING DURATION : 10
5 WIPER-OFF DELAY : 5
Fig. 80