Videotec ULISSE PLUS - Manual (Page 32)

EN - English - I
nstruc
tions manual
30
9.6.4 Housing Serial Port Menu
j Once you have exited from the camera
OSM, press the IRIS CLOSE key to return to
the Pan & Tilt OSM.
j To prevent the camera OSM from
overlapping the Pan & Tilt OSM, exit from
the camera configuration mode before
pressing the IRIS CLOSE key.
01. Protocol: Allows the setting of the protocol
used for the serial communication with the
camera.
02. Baud Rate: Allows the setting of the baud rate
used for the serial communication with the
camera.
03. Return Cmd: Allows the personalization of
the Confirm command ("9.1.1 How to use the
joystick", page 25) for na
vigating inside the
camera OSM.
04. Exit Cmd: Allows the personalization of the
Exit command ("9.1.1 How to use the joystick",
page 25) for na
vigating inside the camera
OSM.
05. Enable Camera OSM: Allows access to the
camera configuration mode.
HOUSING SERIAL PORT
------------------------
1>PROTOCOL : NONE
2 BAUDRATE : 9600
3 RETURN CMD: IRIS CLOSE
4 EXIT CMD : IRIS OPEN
5 ENABLE CAMERA OSM >
Fig. 64
Example: To enable masking of zone 1 when the
device is in the +15° and +45° position, proceed as
follows:
• Set the Nr parameter value to 1.
• Enable zone masking by setting the Enabling
value to Y.
• Set the Start parameter value to +015.00.
• Set the Stop parameter value to +045.00.
• Change the displayed text by selecting the Text
option, where required.
j Set the Start and Stop menu values to zero
to disable the masking option. If a number
of masks are superimposed, the mask with
the lowest number will prevail over the
others.
j To define the masks, proceed in a clockwise
direction as seen in the diagram.
0°
Start1=15°
Stop1=45°
Start2=170°
Stop2=225°
270°
90° 180°
Fig. 63