Ag Leader EZ-Guide Plus Getting Started Guide - Manual (Page 63)

EZ-Guide Plus Lightbar Guidance System Getting Started Guide Troubleshooting 61
A single LED is
flashing The ambient temperature
is outside the lightbar
temperature range If it is cold, turn on the heater in the cab. If it is hot, turn on
the air conditioning. If sun is shining directly on the lightbar,
shade the lightbar from the sunlight.
The lightbar is not
securely mounted The suction cup is a
temporary mounting
device Pump the suction cup each day or when the red line
appears.
Glue the suction cup to the window.
Mount the lightbar bracket directly on the dash, ceiling, or
window.
For more information, see page 11.
Coverage area value
is not saved over a
power cycle Guidance was not
paused before power
was disconnected. Always pause guidance before disconnecting power.
The lightbar will not
work after lunch The lightbar will not work
if it gets too hot. When
you take a break, do not
leave the lightbar where
it may become very hot,
such as in direct
sunlight. To enable normal operation, reduce the temperature of the
lightbar by turning on the vehicle air conditioning or
shielding the lightbar from direct sunlight.
The IN HEADLAND!
warning is not
displayed
The IN HEADLAND!
warning only appears if
your antenna offset is set
to 0.
You can achieve a similar effect by setting the HEADLAND!
warning lead time to greater than 0 (for example,
3 seconds). The
HEADLAND! warning will then appear
before the headland is reached.
Problem Possible cause Solution