Ag Leader EZ-Guide Plus Getting Started Guide - Manual (Page 52)

50 Using GPS EZ-Guide Plus Lightbar Guidance System Getting Started Guide
To simultaneously receive and output NMEA messages, attach the lightbar and
external receiver to a computer or device and then configure the lightbar and external
receiver. For more information, refer to the EZ-Guide Plus Lightbar: Using
Simultaneous NMEA Input and NMEA Output Support Note on www.EZ-Guide.com.
High accuracy smart antenna
The following figure shows how to connect the high accuracy smart antenna to the
lightbar.
Note — If using a high accuracy smart antenna with a lightbar which does not have
an integrated GPS receiver, you do not need to change any settings on the EZ-Guide
Plus lightbar guidance system. If you are using a lightbar with internal GPS, set the
Data Port to TSIP Receiver.
Configuring the receiver
When the high accuracy smart antenna is connected to the EZ-Guide Plus lightbar
and the Input field on the Data Port Settings screen is set to TSIP Receiver, the
receiver is automatically configured.
P/N 52033
P/N 52026-00
Lightbar
High accuracy smart antenna
P/N 50166
Optional remote control