Installing the system, Mounting the lightbar – Ag Leader EZ-Guide Plus Getting Started Guide User Manual
Page 13
EZ-Guide Plus Lightbar Guidance System Getting Started Guide
Introduction 11
For more information and ordering details, contact your local reseller.
C
CAUTION — Keep the lightbar dry. Do not spray the lightbar with any type of liquid as
this will cause it to fail.
Inspect all contents for visible damage, such as scratches or dents. If any
components appear damaged, notify the shipping carrier. Keep the shipping and
packaging material for the carrier’s inspection.
Installing the system
1.
Assemble the bracket kit. The bracket is reversible to optimize it for roll angle. For
more information, refer to the instructions in the bracket kit.
2.
Attach the suction cup to the bracket.
3.
Attach the power cable to the lightbar.
4.
Mount the lightbar in the required position on the window. See
.
5.
Attach the antenna to the magnetic mount.
6.
Connect the antenna cable to the antenna and route the cable to the cab.
7.
Attach the magnetic mount to the cab roof, along the vehicle centerline. Do one
of the following:
–
If the cab roof is steel, attach the magnetic mount directly to the roof.
–
If the cab roof is not steel, attach the metal plate to the cab roof. Then
attach the magnetic mount to the metal plate.
8.
Connect the antenna cable to the lightbar.
9.
Plug the power cable into the vehicle cigarette lighter. See
Mounting the lightbar
C
CAUTION — The suction cup mount is a temporary mounting device. Before you use
it, read the manufacturer’s instructions provided with the mounting kit.
1.
Dampen the rubber seal on the suction cup.
2.
Place the suction cup on a clean section of window, and then pump the plunger
until its red line is no longer visible.
In addition:
•
To ensure that the lightbar stays securely attached, pump the suction cup each
day, or whenever the red line appears on the plunger.
•
If the lightbar does not stay securely attached with the suction cup, you can glue
the cup to the window. Or, attach the lightbar bracket directly to the dashboard,
ceiling, or window.