Ag Leader EZ-Guide Plus Getting Started Guide - Manual (Page 45)

EZ-Guide Plus Lightbar Guidance System Getting Started Guide Using GPS 43
To select the GPS receiver that will be used with the lightbar:
1. Select Lightbar / Data Port Settings.
2. Select the Input field and then press u or D :
Diagnostics
The diagnostic menus of the EZ-Guide Plus lightbar display information about the
quality of the GPS and DGPS signal. This may be useful when troubleshooting GPS
faults.
GPS diagnostics
Select GPS / GPS Diagnostics to view GPS and receiver
information. There are several screens of information.
• To change to another screen, press u or D .
• To return to the GPS menu, press o .
DGPS diagnostics
Select GPS / DGPS Diagnostics to view information
about DGPS satellites. There is one screen of
information for each DGPS satellite for the selected
correction type.
• To change to another satellite, press u or D .
• To return to the GPS menu, press o .
Select input type ... For ... Notes
None integrated receiver
TSIP Receiver TSIP-capable GPS
receivers This option automatically configures the
receiver to the correct baud and parity
and NMEA messages and rate.
External GPS other GPS receivers Confirm that the port settings match the
receiver output.
Autopilot Autopilot systems
Corrections external RTCM corrections
from a radio Confirm that the data port settings
match the receiver output settings.
Diagnostics diagnostics with AgRemote You cannot use the Auto port
configuration / Force connection
options in AgRemote. You must manually
set the parity and baud options in the
Data Port Settings screen to match the
AgRemote settings.