Ag Leader EZ-Guide Plus Getting Started Guide - Manual (Page 19)

EZ-Guide Plus Lightbar Guidance System Getting Started Guide Getting Started 17
Pass code restriction
The EZ-Guide Plus lightbar has a pass code option that protects the lightbar
configuration settings from being accessed and modified.
Enabling or disabling the pass code
1. From the configuration menu, select Pass Code. The
Pass Code screen appears.
2. Press u or D to select the required option and then
press o .
You are returned to the main menu.
If the Pass Code option has been set to On, then you are
prompted to enter the Pass Code when you select
7
or press m .
Pass Code entry
The correct Pass Code is "2005". To enter the code when
the Enter Pass Code screen appears:
1. Press u or D until the correct digit appears in the
column.
2. Press o to select the next column.
3. Repeat Steps 1 and 2 until all four digits are correct.
If you enter the wrong code, you are returned to the main
screen.
Adjusting the brightness and contrast
You can view the LCD screen in all conditions—from bright
sunlight to night time.
If necessary, use Lightbar / Contrast / Brightness to
adjust the screen contrast, turn on the backlight, or adjust
the backlight and LED brightness.
The lightbar retains its backlight setting even if the lightbar is reset to the default
settings.
B
Tip — If the backlight is configured to On, it automatically turns off during daylight
hours, and turns back on in the late afternoon. When the backlight is enabled but
currently not on, the Backlight setting displays Auto.