HP MPX200 Multifunction Router - Manual (Page 65)

3–Viewing Router Information
Router Blades
ISR654602-00 H 3-9
 Hardware Version identifies the router blade hardware version number.
Starting with version 6, the hardware supports IPv6.
 Software Version identifies the version of firmware loaded on the router
blade. IPv6 requires software version 2.4.0.0 or later.
 iSCSI Port Count specifies the number of iSCSI ports (4) on the selected
router blade.
 Fibre Channel Port Count specifies the number of Fibre Channel ports (2)
on the selected router blade.
 Temperature (Front/Rear/CPU1/CPU2) shows the current temperatures in
degrees Centigrade for the router blade.
 System Uptime indicates the number of days, hours, minutes, and seconds
that the system has been up since booting after the last shutdown or reboot.
 System Settings provides the following options:
 System Log Level: Select 0, 1, or 2 to specify the level of logging,
where levels 1 and 2 will impact performance.
 SSH Enabled: Select Enabled or Disabled to allow or deny access to
the router through SecureSHell (SSH).
 Telnet Enabled: Select Enabled or Disabled to allow or deny access
to the router through Telnet.
 FTP Enabled: Select Enabled or Disabled to allow or deny access to
the router through FTP.
 Target - LUN Settings provides the following options:
 Target Access Control: Select Disabled (the default setting) to
present all targets to all initiators. Or, select Enabled to obtain more
control over which iSCSI targets are presented to which initiators.
Target access control allows you to restrict access to iSCSI targets
from initiators, per router blade. When enabled, the targets are
presented to an initiator only if one or more LUNs are presented to that
initiator from that target. Note that if the Controller LUN AutoMap
option is enabled (the default setting), the Target Access Control has
no effect on targets that have controller LUNs. Therefore, on storage
arrays that have a controller LUN, you must disable the Controller
LUN AutoMap option and enable the Target Access Control to
obtain the needed access control. In addition, when Target Access
Control is enabled, the target is presented to an initiator if one or more
LUNs are mapped to that initiator from any VP group. That is, the host
“sees” all VP groups, even if the LUNs are presented only from one of
the VP groups from that target.