HP MPX200 Multifunction Router - Manual (Page 131)

4–Viewing Service Information
Blade
ISR654602-00 H 4-3
 The Data Migration Usage Information section provides the amounts of
capacity licensed, consumed, scheduled or in-process, and available.
 The Array Based Licenses Information section provides quantities of
migration array-based licenses issued, used, and available.
 Select the Data Migration Report check box to specify settings for
uploading, saving, or clearing information in the data migration report. For
more information, refer to the Data Migration Solution for iSR6200 User’s
Guide.
 In the URL box, type the URL where you want to save or upload the
report.
 Then click the buttons to specify the following options:
 Click Set URL to save the event notification address (specified in
the URL box) that indicates where you want to upload the report.
If you do not click Set URL, the URL is not saved.
 Click Upload Report to send the report to the Web page
indicated in the URL box.
 Click Save Report to create a report and save it in the router's
ftp folder.
 Click Clear Report to delete all reports from the router’s ftp
folder.
 The Migration Parameters section is visible only if the selected blade is
licensed for data migration. It provides the following information:
 Local Migration Periodic Flush Interval (seconds) indicates the
number of seconds that the iSR6200 waits before starting to flush the
DRL for online, local migration jobs. Valid values are 30 through
172800 (48 hours); the default is 30. QLogic recommends that you do
not change the default value.
 Remote Migration Periodic Flush Interval (seconds) indicates the
number of seconds that the iSR6200 waits before starting to flush the
DRL for online, remote migration jobs. Valid values are 900 through
172800 (48 hours); the default is 900. QLogic recommends that you do
not change the default value.
 Job Auto-failover Timer (seconds) indicates the number of seconds
that the iSR6200 waits for the source or destination LUN to come up
after the job owner blade is powered down or the source or destination
LUN becomes unavailable on the owner blade. After this time is
reached, the job is moved to the peer blade, where both the source
and destination LUNs are available. Valid values are 600 through
172800 (48 hours); the default is 172800. QLogic recommends that
you do not change the default value.