HP MPX200 Multifunction Router - Manual (Page 120)

3–Viewing Router Information
FCIP Routes
3-64 ISR654602-00 H
 VLAN Priority specifies the priority of the VLAN assigned to the FCIP route
when VLAN use is enabled. In a network with multiple VLANs, the VLAN
Priority box prioritizes Ethernet traffic by giving higher preference to traffic
in the network over non-VLAN traffic and traffic from VLANs with lower
priorities. Level 1 is the lowest priority, level 7 is the highest priority, and
level 0 specifies no VLAN.
 FCIP SW Compression indicates whether software compression is
enabled, disabled, or automatic. Depending on the data, software
compression may result in lower bandwidth use. If the data are highly
compressible, the compressed FCIP PDU is significantly smaller than the
original Fibre Channel frame.
 Bandwidth (Mbit/sec) allows you to specify the amount of WAN bandwidth
the FCIP route is allowed to consume. If there are data available to the
router to transmit, the router limits the transmit rate to this value.
If you modify the FCIP route information on this page, click Save to preserve your
changes.