HP MPX200 Multifunction Router - Manual (Page 60)

3–Viewing Router Information
Router iSR6200 Chassis
3-4 ISR654602-00 H
Table 3-1 shows the internal temperature limits set to trigger events or alerts.
Power Cooling Module x
The Power Cooling Module x section of the Router iSR6200 page provides the
following information about each router blade:
 Status shows whether the PCM is installed.
 Power Supply indicates whether the power supply is Connected or
Unplugged.
 Fan1 reports the condition of the first fan in the PCM: Healthy or Faulty.
 Fan2 reports the condition of the second fan in the PCM: Healthy or Faulty.
 Fan3 reports the condition of the third fan in the PCM: Healthy or Faulty.
Table 3-1. Internal Temperature Sensor Limits
Sensor
High Fan
Speed
Temperature
Low Fan
Speed
Recovery
Temperature
Critical
Temperature
(power off)
SMB_Alert
Recovery
Temperature
Front 60°C 55°C 70°C 55°C
Rear 45°C 45°C 55°C 40°C
CPU1 60°C 55°C 68°C 55°C
CPU2 60°C 55°C 68°C 55°C
Table Notes
High Fan Speed Temperature—When a sensor detects a temperature that exceeds this value,
the fans runs at their maximum speed. The system logs an event and the Alert LED blinks five
times every two seconds.
Low Fan Speed Recovery Temperature—When the fans are running at their maximum speed
and all sensors report values less than this value, the fans return to normal speed.
Critical Temperature—When a sensor detects a temperature that exceeds this value, the system
powers down the blade. When this happens, the CPUs enter sleep state 5; the system sets the
PCI power state of capable devices to D3 and turns off the power supplies that are not essential to
wake up the CPUs. When the temperature falls below the recovery temperature, the sensor that
reported the over-temperature value generates an SMB_ALERT.
Recovery Temperature—This is the value at which a sensor generates an SMB_ALERT to wake
up the CPU and cause the blade to reboot.