HP MPX200 Multifunction Router User Manual
Page 181
B–Log Messages
ISR654602-00 H
B-21
107078
#%d: QLUpdatePort 0x%x: out of slots in
host database
FC
Error
Driver was unable to re-establish connection to the
target within the time-out and retry counts, and is
therefore marking it offline.
107984
#%d: QLWriteFlashDword: Write fails at
addr 0x%x data 0x%x
FC
Error
Fibre Channel controller failed a Flash write
(address x data x).
108032
#%d: QLGetVpDatabase:
MBOX_CMD_GET_VP_DATABASE for VP %d fatal
error
FC
Error
Fibre Channel controller failed the Get VP Database
command (for virtual port %d).
108033
#%d: QLGetVpDatabase:
MBOX_CMD_GET_VP_DATABASE for VP %d failed
%x
FC
Error
Fibre Channel controller failed the Get VP Database
command (for virtual port %d) with status x.
108049
#%d: QLVerifyMenloFw:
EXECUTE_COMMAND_IOCB failed MB0 %x MB1 %x
FC
Error
Fibre Channel controller reported failure status for an
Execute IOCB (input/output control block) command.
108050
#%d: QLVerifyMenloFw:
EXECUTE_COMMAND_IOCB fatal error
FC
Error
Fibre Channel controller reported a fatal error while
processing an Execute IOCB command.
108064
#%d: QLGetFwState: Get Firmware State
failed 0-3 %x %x %x %x
FC
Error
Fibre Channel controller reported failure status for a
Get Firmware State command.
118882
#%d: QLIoctlDisable: Reset adapter
FC
Info
Request to reset the Fibre Channel processor
(adapter) received from IOCTL interface.
119088
#%d: QLIsrEventHandler: LIP occurred
(%x): mailbox1 = %x
FC
Info
Fibre Channel loop initialization process (LIP)
occurred. The LIP type is reported, as is the contents
of the Fibre Channel processor’s mailbox 1 register.
Table B-1. iSR6200 Router Log Messages (Continued)
ID
Log Message
Module
Type
Msg.
Type
Description