HP Insight Cluster Management Utility - Manual (Page 16)

•
Parameters that affect the behavior of the local disk controller. Parameter names can differ
from one server to another and cannot be documented exhaustively.
IMPORTANT: If the boot order is not correctly set, then cloning and backup fail on the cluster.
Examples are provided in the following sections.
2.1.8.1 DL3xx, DL5xx, DL7xx, Blades
Parameters:
•
Virtual serial port COM1
•
Embedded NIC
NIC 1 PXE boot or PXE enabled ◦
◦ NIC 2 Disabled
◦ NIC 3 Disabled (not always present)
◦ NIC 4 Disabled (not always present)
•
Boot order
PXE 1.
2.
CD
3. DISK
•
BIOS Serial console
BIOS Serial Console Auto ◦
◦ Speed 9600 Bd
◦ EMS Console COM1
◦ Interface Mode Auto
2.1.8.1.1 OA IP address: Blades only
Assign the OA IP address in the same subnet as the administration network.
2.1.8.1.2 Configuring iLO cards from the OA: Blades only
Use the EBIPA to assign consecutive addresses to the iLO:
•
16 addresses on the c7000 Enclosure
•
8 addresses on the c3000 Enclosure
To configure the iLO cards:
1.
Open a browser to the OA.
2. In the right window, select Device Bays.
3. Select Bay 1.
4. In the left window, select the Enclosure Setting tab and then Enclosure Bay IP Addressing.
5. Enter the IP address of the first iLO card.
6. Click Auto Fill or the red arrow.
Each iLO is reset and assigned an IP address by the OA.
7. From the HP Insight CMU management node, ping each iLO.
2.1.8.1.3 Disabling server automatic power on: Blades only
On each Blade server:
16 Installing and upgrading HP Insight CMU