HP Insight Cluster Management Utility - Manual (Page 144)

-i <IP address>
The IP address of the target node to unconfigure.
The unconfigure_node program is expected to unconfigure and/or remove anything related
to the given node. This may include calling /opt/cmu/tools/cmu_remove_node_from_dhcp
to prevent the node from PXE-booting, and to delete any PXE-boot file related to the given compute
node.
8.2.6 Boot diskless node
The boot_node program is called when a compute node is booted from HP Insight CMU into the
HP Insight CMU diskless logical group of type <DISKLESS> (as opposed to a reboot command
from the OS). This program is called with the following arguments:
-l <CMU diskless logical group name>
The name of the diskless logical group.
-s <NFS server IP>
The IP address of the NFS server.
-n <nodename>
The host name of the target node to boot.
-i <IP address>
The IP address of the target node to boot.
-m <MAC address>
The MAC address of the target node to boot.
-e <eth device>
The active Ethernet device of the target node to boot.
The boot_node program is typically a subset of the configure_node program, and ensures
that the given node is ready to be PXE-booted. It may call
/opt/cmu/tools/cmu_add_node_to_dhcp
again, and may check that the correct PXE-boot
file is in place for the given node.
8.2.7 Diskless check
The diskless_check program is called before the configure_node, unconfigure_node,
or boot_node programs are called. This program is called with the following arguments:
-l <CMU diskless logical group name>
The name of the diskless logical group.
The diskless_check program is intended to contain any sanity checks that should be performed
before the configure_node, unconfigure_node, or boot_node programs are called. It can
also be called directly by the build_image program, to ensure that any prerequisites are met
before the diskless image is created. For example, the system-config-netboot implementation
requires that the system-config-netboot rpm provided by HP Insight CMU be installed on
the HP Insight CMU management server. A check for the existence of this rpm is performed by the
cmu_system-config-netboot_diskless_check
program.
After these programs are created, tested, and installed in the /opt/cmu/
diskless/
<DISKLESS>/ directory, then you are ready to add this implementation "toolkit"
to HP Insight CMU. To do this, add the <DISKLESS> implementation type to the
CMU_VALID_DISKLESS_TOOLKITS
variable in /opt/cmu/etc/cmuserver.conf.
NOTE: If more than one valid diskless type will be available in HP Insight CMU, this variable
must be comma-separated.
144 Advanced topics