HP Library and Tape Tools - Manual (Page 97)

Figure 36 Drive Performance Results tab
Running on non-Windows
For Linux, HP-UX, Solaris, VMS, and MAC OS X, the devperf command is available for libraries
and tape drives. In the case of a library, the test can only be run on the drives associated with the
selected library. If multiple drives are selected, the test will be run in parallel on all of the drives.
For Tru64, the devperf command is only available for tape drives and the test can only be run
on one drive at a time.
To start the Drive Performance test (CSI version):
1. Use the select command to select the device to be tested.
select (where <n> is the number of the device to be examined)
2. The Device Performance Tool screen shows the drives on which test can be run. For a library,
only the drives associated with the library are selectable.
Performance tests 97