Installation check test, Connectivity test, Installation check test connectivity test – HP Library and Tape Tools User Manual
Page 86
•
•
“Initialize Element Status test” (page 92)
•
“Restore Factory Default Settings test” (page 93)
Installation Check test
Table 13 Installation Check test details
Installation Check test
Details/Other test
The Installation Check is not executed in the same way as other L&TT. tests. Rather, it
is run automatically when L&TT starts in Installcheck mode. Installcheck mode is a
feature of the Windows version of L&TT.
Description
When run in Installcheck mode, L&TT checks the installation of selected devices. L&TT
performs several tests on each selected device to determine if the device is configured
optimally. In addition, L&TT performs connectivity and configuration tests on all
supported devices that are configured on the system. These tests cannot be overridden.
All of the tests performed during the installation check can also be run manually with
L&TT. L&TT displays the results of each test and any recommendations.
NOTE:
When L&TT is run in Installcheck mode, the Installation Check wizard appears.
After the selected tests are complete and the results are displayed, the wizard closes,
which also closes L&TT. If you want to restart L&TT, launch it as you normally would
(without the mode=installcheck argument if you are starting it from the command line).
For instructions on how to perform this test, see
“Running tests and device-specific
or
“Running the tests (CSI)” (page 50)
For information on starting L&TT in Installcheck mode, see Using the Installation Check
feature (page 172).
Run L&TT in Installcheck mode when you want to verify the correct configuration of
supported devices.
When to run
None
Duration
The installation check feature is currently supported on the following devices:
Available for
•
HP Ultrium drive
•
HP SDLT 320 drive
•
HP VS80 drive
•
DDS tape drives
Connectivity test
Table 14 Connectivity test details
Connectivity test
Details/Other test
Writes data to the internal buffers in your product to verify that the physical connection
between your host and the storage device is operational. No media is required.
Description
NOTE:
•
If no options are specified, by default L&TT runs the test with looping options set to
Count based loop with a looping value of 1.
•
Test will not overwrite any data on media present in the drive.
•
For instructions on how to perform this test, see
“Running tests and device-specific
or
“Running the tests (CSI)” (page 50)
.
•
The Connectivity test is available from the command line syntax. For more
information, see
“Running tests (CLF)” (page 64)
When there is a question about the integrity of the bus connection from the device to
the host computer.
When to run
< 1 minute
Duration
86
Tests