HP Library and Tape Tools - Manual (Page 16)

Starting L&TT
1. Launch the HP L&TT by double-clicking the L&TT shortcut icon on the desktop or click Start >
Programs > HP Library and Tape Tools > HP L&TT.
2. Login with the UserName and Password.
NOTE: The default username and password is administrator and administrator respectively.
3. Click Sign In. The HP L&TT Startup screen is displayed.
The Startup screen gives you the opportunity to exit the application if it was started unintentionally
and before any SCSI bus activity occurs. This prevents the program from interfering with any backup
or other storage applications that is currently running as shown in
Figure 2 (page 16) . The Startup
screen allows you to select the initial scan mode and the SCSI I/O mode (if more than one option
is available).
LTT displays a warning message to shut down any backup applications and services at the start
of the application.
Figure 2 HP L&TT Startup screen with warning message
Scan Mode
Hardware Scan
When your application starts for the first time it performs a device scan to identify all the devices
connected to the computer, either directly or through a SAN. The first time L&TT is run, it performs
a full hardware scan (Hardware Scan option) and the results of the scan are automatically
saved. When starting L&TT next time, the Saved/Manual Scan option can be used.
NOTE: If the Saved/Manual Scan option is selected before a hardware scan is done, the list
of available devices will be empty.
16 Using L&TT on Windows