HP XP P9000 Command View Advanced Edition Software - Manual (Page 64)

Notes Description Parameter
You must supply this value. Because
storage groups are not supported in Ex-
change Server 2010, use a value of 1
in this case.
Number of storage groups to back
up per database server (for Exchange
Server 2010, use a value of 1)
SG_NUM
You must supply this value. Number of database servers DB_SERVER
You must supply this value.
Time allowed for backing up the en-
tire system (seconds)
SYSTEM_BACKUP_TIME
You must supply this value based on
Parallel performance .
Parallel verification count VERIFY_PARA
Depends on the performance of the
storage and the server.A value of 50 MB
per second is assumed for the calcula-
tion.
Verification performance of the in-
formation store (MB/second)
IS_VERIFY
Depends on the performance of the
storage and the server.A value of 7 per
second is assumed for the calculation.
Verification performance of the
transaction log file (per second)
LOG_VERIFY
You must supply this value. Depends on
the performance of the storage and the
server. Time required to re-synchronize the
pair to back up per database server
(seconds)
RESYNC_TIME
Related topics
• Setting Application Agent options , page 59
About VDI generation timeout
The VDI Meta File Generation Timeout setting is located in the SQL Option tab in the Setup Application
Agent dialog box. It indicates the time it will take to back up or restore an SQL Server database. If
an inappropriate timeout value is specified, the following problems might occur:
• If too small a timeout value is specified, the backup fails due to a timeout, resulting in a failure to
back up the database.
• If too large a timeout value is specified, a client application connecting to SQL Server will time
out before the backup itself fails by timing out.
Specify a value of at least 20 minutes, or follow this procedure to determine a timeout value suitable
for your operating environment:
1. Set the VDI generation timeout to a large initial value, such as 3600 seconds.
2. Perform a backup.
3. Refer to Time for Completion in the Task Log dialog box and estimate the time it will take to
complete a normal backup.
4. Because the time it will take to complete the backup depends on the state of the system resources,
revise the VDI generation timeout to a value slightly greater than the time calculated in step 3.
Refreshing Application Agent
After updating an instance of Application Agent, you need to refresh the data. Replication Manager
then retrieves the following information:
Setting up information sources 64