HP XP P9000 Command View Advanced Edition Software - Manual (Page 200)

Remarks
Default
value Specifiable val-
ues
Item specified Options Pair command
The values Read Only and Read Write are
displayed in this order.
Read Only
Read Only,
Read Write
Whether to per-
mit writing to the
S-VOL after the
split operation.
Secondary
Mode
on: The pair status is immediately set to
DUPLEX.
off: The pair status is set to DUPLEX when
the data copy has finished.
off on, off
Whether to im-
mediately per-
form re-synchron-
ization.
Quick Resync
resync
SELECT(ALL),VOLUNIT is specified in the
BCM command. The command is also
executed for pairs whose status is not
available for the command. The command
is executed on a pair basis even though
execution by group is possible.
Note: The Force option affects all pairs,
regardless of their individual statuses.
off on, off
The operation is
performed on a
volume basis.
The command is
executed for all
pairs regardless
of their status.
force
on: A copy pair is created even when the
S-VOL (or P-VOL when Reverse is specified)
is online.
off: A copy pair is not created if the S-VOL
(or P-VOL when Reverse is specified) is
online. If the volume is online, no error
occurs during an operation performed on
C/T groups, but an error message is issued
during an operation performed on pairs.
Note: Overwrite ONLINE target volume
makes up a copy pair even if the primary
volume in the configuration definition is
online. Ensure that the primary volume is
not being used.
off on, off
Whether to cre-
ate a copy pair
when the copy
destination
volume is online.
Overwrite ON-
LINE target
volume
on: The pair status is immediately set to
DUPLEX.
off: The pair status is set to DUPLEX when
the data copy has finished.
off on, off
Whether to im-
mediately per-
form restoration.
Quick Restore
restore
SELECT(ALL),VOLUNIT is specified in the
BCM command. The command is also
executed for pairs whose status is not
available for the command. The command
is executed on a pair basis even though
execution by group is possible.
Note: The Force option affects all pairs,
regardless of their individual statuses.
off on, off
The operation is
performed on a
volume basis.
The command is
executed for all
pairs regardless
of their status.
force
Managing pair life cycle 200