HP Remote Assistant Card User Manual
Page 95
3 Server Software Installation and Configuration
77
3. Edit your CONFIG.SYS file to include the following lines:
DEVICE=C:\HPNSA\HPASR.SYS
RUN=C:\HPNSA\ASRSET.EXE/ENABLE
Configuring ASR for OS/2
When the ASR driver loads it is not enabled. Adding the RUN command to
CONFIG.SYS (described above) enables ASR. You can also change the default ASR
parameters in CONFIG.SYS. For example, you could enable ASR and set the ASR
time-out to five minutes by adding the following line to CONFIG.SYS:
RUN=C:\HPNSA\ASRSET.EXE /t5
You can also run ASRSET from an OS/2 command prompt using the parameters
described in the following section.
ASR Program Files and Parameters for OS/2
The following program files provide ASR for OS/2:
•
HPASR.SYS. The ASR driver. It notifies HP Remote Assistant that OS/2 is
running.
•
ASRSET.EXE. This utility runs from the OS/2 command prompt and accepts the
following parameters:
/enable
Enable ASR timer.
/disable
Disable ASR timer.
/txx
Set ASR timeout to xx minutes. The ASR timeout is the time after
which the server will restart after a crash or hang.
/status
Show ASR timer status.
•
ASRSET.EXE. This utility runs a detached process and works in conjunction with
the HPASR.SYS driver.