HP Remote Assistant Card - Manual (Page 86)

3 Server Software Installation and Configuration
68
Examples
To set the read/write community name to secret, enter the following command:
LOAD SNMP ControlCommunity=secret
To disable all read/write access, enter the following command:
LOAD SNMP ControlCommunity
To allow any community name to be used for read access, enter the following
command:
LOAD SNMP MonitorCommunity=
To allow any community name read-only access and to set the read/write community
name to private, enter the following command (note the abbreviated option names):
LOAD SNMP M= C=private
To set the community name for traps to AgentTrap, enter the following command:
LOAD SNMP TrapCommunity=AgentTrap
Setting Up ASR for NetWare
This installation procedure assumes that a Novell NetWare server and client have
already been set up correctly.
Perform the following steps to install ASR for NetWare:
1. Insert the disk labeled HP Remote Assistant Server Diskette into a floppy drive on
the client (for example, drive A:).
2. Map a drive letter from the client to the server's SYS:\SYSTEM directory.
3. Copy the HPRADRV.NLM and HPASR.NLM program files from A:\NETWARE
to the SYS:\SYSTEM directory.
To enable ASR automatically each time your server is started, insert the command
LOAD HPASR into the server's AUTOEXEC.NCF file, then restart the server to
activate ASR.
To enable ASR manually, Type the command LOAD HPASR at the server's console
prompt and press Enter.