HP Remote Assistant Card - Manual (Page 153)

C Modem Commands
135
Command Values Def Description
$EBn n = 0 or 1 *** $EB0 enables 10 bit mode.
$EB1 enables 11 bit mode.
%En n=0 thru 5
***
% E0 = Modem Won’t Escape.
% E1 = +++ Method (default setting).
% E2 = Break Method.
% E3 = Either +++ or Break Method.
% E4 = No "OK" Response to +++
% E5 = "OK" Response to +++
#Fn n = 0 or 1
***
#F0 means no fallback when on-line.
#F1 means fallback from 14400 to 4800 bps when on-line.
#F2 means fallback to 4800 bps from 14.4K bps/fall forward
when line improves.
&F n= 0, 8 or 9
***
&F loads factory default values from ROM and DIP-Switch
settings.
&F8 reads factory defaults and Switch settings when &F is
issued.
&F9 reads parameters stored in Non-Volatile memory when &F
is issued.
$Fn n = 0 or 1
***
$F0 means do not fall back to normal connect if CR received.
$F1 means fall back to normal connect if CR received.
&Gn
(Not
applicable in
the U.K.)
n = 0, 1 or 2 *** &G0 turns off CCITT guard tones.
&G1 turns on CCITT 550 Hz guard tone.
&G2 turns on CCITT 1800 Hz guard tone. (default for Italy and
New Zealand)
Hn
(Not
applicable in
France)
n = 0 or 1 H0 means Hang Up (go on hook).
H1 means Go Off Hook.
In n = 0,1 or 2 I0 requests modem ID #.
I1 requests firmware revision #.
I2 for internal use.
L5 L5 lists all current operating parameters.
L6 L6 lists all current S-Register values.