HP Remote Assistant Card - Manual (Page 77)

59
3 Server Software Installation and
Configuration
This chapter describes how to set up your server using the HP Remote Assistant
software for remote server management. Installing the server software is the first half
of the installation process, and involves three steps:
1. Installing the DOS-based HP Remote Assistant server software
2. Installing the NOS-based HP Remote Assistant server software
3. Configuring the SNMP Agent to send traps to your console.
Once you've installed the HP Remote Assistant software on your server and configured
the HP Remote Assistant, you must then install the remote console software (as
described in Chapter 4) before you can begin to manage your server from a remote
location.
NOTE If you have earlier versions of HP Remote Assistant software installed, it's
safe to overwrite them with the new versions.