HP Remote Assistant Card - Manual (Page 50)

2 Hardware Installation and Configuration
32
Starting the HP Remote Assistant Configuration Utility
There are several ways to start the HP Remote Assistant Configuration Utility:
From the HP NetServer Navigator Configuration Assistant, click
Execute Card Utilities
This option allows execution of utilities in addition to the Remote Assistant
Configuration utility.
OR
From the HP NetServer Navigator's Main Menu, click NetServer Utilities, then click
the Remote Assistant Configuration Utility button.
OR
Boot the Utility Partition by pressing F12 when prompted during system boot-up.
Select Remote Assistant Utility then Remote Assistant Configuration Utility.
OR
If you have a bootable DOS partition on your hard disk that you previously copied
Remote Assistant files to using the INSTALL.EXE utility, simply boot to this partition
and, at the DOS prompt, type:
hprautil
OR
Execute the utility from the HP Remote Assistant Server Diskette. Boot DOS from a
bootable floppy, remove the DOS floppy and insert the server diskette, then type:
a:\dos\hprautil
If this is the first time you are configuring the board, or if the board's non-volatile
memory has been corrupted, the utility displays a message informing you that the
board is currently configured with default values.
NOTE Configuration information provided through the HP Remote Assistant
Configuration Utility is saved in non-volatile, on-board memory, and so the
information is retained when the board is powered off.