HP Remote Assistant Card - Manual (Page 152)

C Modem Commands
134
Command Values Def Description
&BSn n = 0 or 1
***
&BS0 means maximum transmit block size of 64 characters.
&BS1 means maximum transmit block size of 256 characters.
$BAn n = 0 or 1 *** $BA0 means Baud Adjust is off, speed conversion is on.
$BA1 means Baud Adjust is on, speed conversion is off.
&Cn n = 0, 1, 2,
or 4
***
&C0 forces Carrier Detect on.
&C1 lets Carrier Detect act normally.
&C2 lets Carrier Detect drop S24 time on disconnect.
&C4 resets modem when Carrier Detect drops.
Ds s = phone # Dial a telephone number “s,” where s may include up to 60
digits or T, P, R, comma and ; characters.
&Dn n = 0, 2, or 3
***
&D0 DTR is ignored.
&D1 means modem returns to command mode.
&D2 lets modem react to DTR normally.
&D3 causes modem to reset to modem default parameters.
En n = 0 or 1
***
E0 means do not echo Command Mode characters.
E1 means do echo Command Mode characters.
&En n = 0 thru 13
***
***
***
***
***
***
&E0 means V.42 Normal Mode.
&E1 means V.42 Auto-reliable Mode.
&E2 means V.42 Reliable Mode.
&E3 means no modem-initiated flow control.
&E4 means CTS modem-initiated flow control.
&E5 means Xon/Xoff modem-initiated flow control.
&E6 means Xon/Xoff not passed through.
&E7 means Xon/Xoff passed through.
&E8 means Enq/Ack pacing off.
&E9 means Enq/Ack pacing on.
&E10 means Normal Mode flow control off.
&E11 means Normal Mode flow control on.
&E12 means Pacing off.
&E13 means Pacing on.