HP Remote Assistant Card - Manual (Page 39)

2 Hardware Installation and Configuration
21
Verifying Board Installation
You can verify that the Remote Assistant accessory board has been correctly installed
by powering on the server and checking the board’s diagnostic LED at the rear of your
system. If installed properly, the LED power-on sequence appears as follows:
•
Remains off for about 3 seconds
•
Turns solid green for a short time (a maximum of 15 seconds)
•
Turns off for 10 seconds
•
Alternately flashes green and yellow
The actual duration for each phase depends on the server model, its configuration, and
on the presence (or absence) of an on-board modem.
If the LED does not display at all within 20 seconds of power on, or if it flashes a red
error code, there may be a problem with the board. For descriptions of possible board
problems and LED light sequences, see Appendix H, "LED Codes."
Figure 2-11. HP Remote Assistant EISA Board
CAUTION Make sure that the reset button on the board is pushed in, otherwise the
server may not power on. The reset button pops out during a graceful
shutdown or a remote shutdown.