HP NonStop G-Series - Manual (Page 92)

FSAC
Represents the actual presence of the FCSA FSAC containing the
backup disk path SCSI controller. This attribute is displayed only if the
physical FCSA FSAC is not present.
Port Name
A number that uniquely identifies the port through which the disk is
connected.
Primary Path
Configured FSAC Location
Displays the configured location of the FCSA FSAC containing the
primary disk path SCSI controller. This attribute is displayed even if
the physical FCSA FSAC is not present.
Access State Indicates whether the disk is active or inactive.
LUN
The logical unit number of the disk.
Example: 0
FSAC
Represents the actual presence of the FCSA FSAC containing the
primary disk path SCSI controller. This attribute is displayed only if
the physical FCSA FSAC is not present.
Port Name
A number that uniquely identifies the port through which the disk is
connected.
Process Pair
Primary Process ID
The processor number and PIN of the current primary disk I/O process.
Example: 0,295
Backup Process ID
The processor number and PIN of the current backup disk I/O process.
Example: 0,296
Redundancy Status
The fault-tolerance status of the disk environment.
Values: Fully Redundant, Redundancy Lost
Actions
Abort Backup Path
Terminates operation of the backup path to the disk. When the Abort action finishes, the path is in a
Hard Down state. You must use the Reset Backup Path action before you can start the path again.
Abort Disk
Terminates operation of the all paths for the disk. When the Abort action finishes, the paths are in a
Hard Down state. You must use the Reset Disk action before you can start the paths again.
Abort Primary Path