HP NonStop G-Series - Manual (Page 190)

Stop Monitoring
Stops OSM from monitoring the UPS.
Common Attribute Values
Battery Charge Status
Value Meaning
Absent The battery is not installed.
Charged The battery is fully charged
Charging The battery is in the process of being charged.
Disabled
The battery cannot supply power and cannot be charged, possibly because the Disable
Battery action has been performed. You should disable a battery before removal.
Discharged The battery needs recharging or replacement.
Discharging The system is currently drawing power from the battery.
Enabled
The battery can accept a charge and is ready to supply power if the AC power is
unavailable.
Fault Check the battery for alarms. If the condition persists, contact your service provider.
Unknown The battery is not responding, and its state cannot be determined.
Compare State
Value Meaning
Same Current and default versions are the same.
Up-rev The current version is newer than the default version.
Down-rev The default version is newer than the current version.
Unknown Unable to compare files.
Device State
Value Meaning
Aborting Processing is terminating.
Defined State is defined by the NonStop Kernel operating system.
Degraded Performance is degraded.
Diagnose A diagnostic test is running on the component.
Initializing Processing is starting up.
Not Configured The component is not configured.
Started The component is running.
Starting Processing is starting up.
Stopped Processing has been terminated.