HP NonStop G-Series - Manual (Page 115)

Physically powers off the G4SA.
Reset
Places the G4SA in a state from which it can be started.
Start
Starts the G4SA and the associated G4SA SAC. The G4SA and the SAC must be in the Stopped state
before you perform this action.
Stop
Rather than automatically stopping the G4SA (as the Abort action does), this action first warns you if
the G4SA is currently in use (and stops it only after you confirm).
G4SA PIF
Physical interface (PIF) objects represent each of the four ports on a G4SA through which LAN
connections are made.
Each G4SA PIF has an associated LIF object.
Location in OSM Tree: System > Group > IOAM Enclosure > IOAM > G4SA > G4SA SAC >
G4SA PIF
Example: G4SA PIF $ZZLAN.G4SA1.0.A
Attributes
G4SA PIF
Service State
Displayed in the Attributes tab and Attributes dialog box only if attention or service is
required.
Values
Logical
Configured Interface Type
Displays the configured interface, as specified by the Alter Interface
Type action.
Values: Copper, Fiber, or Autodetect.
Current Configured Speed The transmission rate for the ServerNet addressable controller.
Device State
The state of the component as known to the NonStop Kernel operating
system on the server.
Values
Duplex Mode
The transmission mode for the ServerNet addressable controller.
Values: Half Duplex, Full Duplex, Unknown