HP NonStop G-Series - Manual (Page 214)

SNETMON Process Pair
Redundancy Status
The fault-tolerance status of the SNETMON Process Pair.
Values: Fully Redundant, Redundancy Lost
Backup/Process ID
The processor number and PIN of the backup SNETMON process
($ZZSCL) running on the local node.
Primary/Process ID
The processor number and PIN of the primary SNETMON process
($ZZSCL) running on the local node.
Actions
Rediscover
Causes OSM to refresh and reanalyze the object and all subcomponents. Refresh refers to OSM
updating the attribute values displayed in the OSM Service Connection interface. Reanalyze
refers to the running of OSM incident analysis, which checks EMS event messages and creates
alarms in OSM if certain conditions exist.
Reset ServerNet Statistics
Resets the ServerNet statistical counters to zero for all processors in the system. You can use
this action before performing a specific system activity and then use the Generate ServerNet
Statistics action to get statistics on that system activity.
SCF Equivalent: SCF START SUBSYS $ZZSCL
Set ServerNet Cluster State
Starts or stops the ServerNet Cluster subsystem on the local node.
Parameter: ServerNet Cluster State can be set to Stopped or Started.
Switch SANMAN Process Pair
Switches the SANMAN process from the primary processor to the backup processor.
SCF Equivalent: SCF PRIMARY $ZZSMN
Switch SNETMON Process Pair
Switches the SNETMON process from the primary processor to the backup processor.
SCF Equivalent: SCF PRIMARY $ZZSCL
Update Topology