HP StorageWorks XP Remote Web Console Software - Manual (Page 84)

84 Continuous Access XP Journal
• In the list, select and right-click a remote disk array, and select Edit Path(s). The list displays
information about logical paths.
6. Right-click the list, and select Add Path. The Add Path pane appears.
7. Use the Add Path pane to configure up to eight new logical paths.
8. Click Set to close the Add Path pane.
9. In the Preset list, check the settings you made.
• To modify a setting, select and right-click the setting from the Preset list, and select Modify. A pane
appears where you can modify the setting.
• To cancel a setting, select and right-click the setting in the Preset list, and select Cancel.
10. Click Apply to apply the settings.
NOTE: If an error occurs, the right-most column of the Preset list displays the error code. To view detailed
information about the error, right-click the error code, and select Error Detail. An error message appears
providing detailed information about the error.
Figure 41 Add Path pane
The Add Path pane displays the following:
• Port: Select an initiator port on the local disk array.
NOTE: When specifying a port, use the keyboard to enter the port number. When you enter the
port number, you can abbreviate the port number into two characters. For example, you can enter
1A instead of CL1-A. You can use uppercase and lowercase letters.
• Pair-Port: Select an RCU target port on the remote disk array.
NOTE: When specifying a port, use the keyboard to enter the port number. When you enter the
port number, you can abbreviate the port number into two characters. For example, you can enter
1A instead of CL1-A. You can use uppercase and lowercase letters.
• Set: Closes the Add Path pane, and adds settings to the Preset list.
• Cancel: Cancels settings.