HP StorageWorks XP Remote Web Console Software - Manual (Page 139)

Continuous Access XP Journal user guide 139
Resource Shortage (Port)
or
Resource Shortage (Pair-Port) Disk array rejected the request for
establishing a logical path because
all resources in the local and remote
disk arrays are being used for other
connections.
Delete the failed path and all paths
and remote disk arrays not currently
in use. The local disk array can be
connected to up to 64 remote disk
arrays with up to eight paths to each
remote disk array.
Ensure that all ports on the local and
remote disk arrays are properly
configured: ordinary target ports or
RCU target ports for hosts, RCU
target ports for remote disk arrays,
initiator ports for local disk arrays.
If necessary, connect to the remote
disk array to delete paths or remote
disk arrays and reconfigure ports,
and reconnect to the local disk
array. After that, add the path and
remote disk array again.
Serial Number Mismatch Remote disk array’s serial number
(S/N) does not match the specified
serial number (S/N).
Ensure that you entered the correct
remote disk array S/N and path
parameters (for example, local disk
array port, remote disk array port,
and controller ID). After that, delete
the failed path. You might need to
change the minimum paths setting or
delete the remote disk array to
delete the path. After deletion
finishes, add the path and the
remote disk array.
Ensure that you entered the correct
controller ID. Ensure that the
topology settings of the local and
remote disk array ports are correct.
Invalid Port Specified port is not configured as
an initiator port, or this path already
exists.
Ensure that the topology settings of
the local and remote disk array ports
are correct.
Ensure that you entered the correct
remote disk array S/N and path
parameters (for example, local disk
array port, remote disk array port,
and controller ID). After that, delete
the failed path. You might need to
change the minimum paths setting or
delete the remote disk array to
delete the path. After deletion
finishes, add the path and the
remote disk array again.
Port number invalid Specified port number is invalid. The
cable is not connected to the
specified port.
Delete the failed path. Check the
specified port number or cable
connection, and retry.
Communication error Timeout error occurred in the fibre
path between the local and remote
disk arrays.
Delete the failed path, and retry.
Table 29 Troubleshooting problems with status of logical paths (continued)
Pair status Description Corrective action