Deleting journal groups – HP StorageWorks XP Remote Web Console Software User Manual
Page 102
102 Continuous Access XP Journal
•
Forward Path Watch Time: Specifies if the master journal group’s Path Watch Time value is forwarded
to the restore journal group. If the Path Watch Time value is forwarded from the master journal group to
the restore journal group, the two journal groups have the same Path Watch Time value.
• Yes: Path Watch Time value is forwarded to the restore journal group.
• No: Path Watch Time value is not forwarded to the restore journal group. No is the default.
• Blank: The current setting of Forward Path Watch Time remains unchanged.
CAUTION:
This option cannot be specified at the secondary site.
•
Use of Cache: Specifies if journal data is stored in the restore journal group in cache.
• Use: Journal data is stored in cache.
NOTE:
When there is insufficient space in cache, journal data is also stored in the journal volume.
• Not Use: Journal data is not stored in cache.
• Blank: The current Use of Cache setting remains unchanged.
CAUTION:
This setting does not take effect on master journal groups. However, if you use the RAID
Manager
horctakeover
command to change a master journal group to a restore journal group,
this setting takes effect on the journal group.
•
Speed of Line: Line speed of data transfer. The unit is Mbps (megabits per second).
You can specify one of the following: 256, 100, or 10.
CAUTION:
This setting does not take effect on master journal groups. However, if you use the RAID
Manager
horctakeover
command to change a master journal group to a restore journal group,
this setting takes effect on the journal group.
•
Set: Applies settings in the pane to the Journal Operation pane (”
Displaying the Journal Operation
•
Cancel: Cancels settings.
Deleting journal groups
To delete a journal group from the primary disk array, log into the primary disk array.
To delete a journal group from the secondary disk array, log into the secondary disk array.
NOTE:
You cannot delete master and restore journal groups. You can only delete journal groups whose
attribute is Initial.
1.
Ensure that the Command View XP or XP Remote Web Console main pane is in Modify mode. For
more information, see the HP StorageWorks Command View XP User Guide for XP Disk Arrays or the
HP StorageWorks XP Remote Web Console User Guide for XP12000/XP10000.
2.
Ensure that the Journal Operation pane is displayed (see ”
Displaying the Journal Operation pane
3.
Do one of the following:
• In the upper-right list, right-click a journal group whose attribute is Initial.
• In the tree, select and right-click a journal group in initial status.
4.
Select JNL Groups and Delete JNL.
5.
In the Preset list, check the journal groups you want to delete.