From the optimize menu — import hp ovpa data, From the optimize menu — import hp pmp data – HP Matrix Operating Environment Software User Manual
Page 65
From the Optimize menu — Import HP OVPA data
Prerequisites
•
You must be logged in to Matrix Operating Environment (see
).
•
The system(s) must be discovered by Systems Insight Manager.
Procedure 6 Import HP OVPA data into Capacity Advisor
1.
Click Optimize
→Capacity Planning→Import Capacity Advisor Data→Import OVPA System
Data....
2.
Select the target system(s).
The Verify Targets screen displays.
3.
Verify the target system(s).
You have the opportunity to add or remove systems here. When done, click Next.
The Specify Parameters screen displays.
4.
Specify the begin and end dates desired to define the extent of the collection to import.
For example:
[-b 20071101 -e 20071231]
If no date range is given, all data up to 30 days is imported.
5.
Optionally, specify [-p] if the import is for a non-Matrix OE workload.
6.
Click Run Now.
After a short time, the Task Results screen displays.
For tasks where you select Run Now, a few moments will pass and then you see the Task Results
screen. For general help on interpreting the information in this screen, see the HP Systems Insight
Manager Help on “Viewing Task Results”.
The Task Results screen shows a “Running” check box with a Start time: until the task completes.
When data import finishes, you see an End time: displayed, with standard out (stdout) and standard
error (stderr) information displayed on tabbed panes in this screen. Check both tabs for relevant
information.
From the Optimize menu — Import HP PMP data
Prerequisites
•
You must be logged in to Matrix Operating Environment (see
).
•
The system(s) must be discovered by Systems Insight Manager.
Procedure 7 Import HP PMP data into Capacity Advisor
1.
Click Optimize
→Capacity Planning→Import Capacity Advisor Data→Import PMP System
Data....
2.
Select the target system(s).
The Verify Targets screen displays.
3.
Verify the target system(s).
You have the opportunity to add or remove systems here. When done, click Next.
The Specify Parameters screen displays.
4.
Specify the begin and end dates desired to define the extent of the collection to import.
For example:
[-b 20071101 -e 20071231]
Gathering data for Capacity Advisor
65