HP Matrix Operating Environment Software - Manual (Page 170)

Table 23 Warning Messages in Capacity Advisor (continued)
To correct Probable cause Message
(Options->Protocol Settings->Global
Protocol Settings). process. You can also run vseassist
to troubleshoot connection errors. happen when acimserver
process is not running on the
system.
Synchronize the managed node clock
to the CMS system clock. Capacity Advisor cannot analyze
utilization across multiple systems Sample time sample_time is not aligned
to hour intervals.
or servers when system clocks (and
therefore, data timestamps) are not
synchronized.
Set up the trusted certificate by
manually installing the system's See message text. system_name : HP SIM requires trusted
certificates for managed systems but no
trusted certificate exists for this system.
certificate into the HP SIM Trusted
System Certificate List.
Install the WBEM utilization provider
on the system. See message text. system_name : The Utilization WBEM
Provider is not installed.
On the managed system, execute the
command
/opt/wbem/sbin/cimserver The WBEM provider on the system
is not running and should be
restarted. system_name : The WBEM server is not
running and should be restarted.
See message text. See message text. system_name : Upgrade the Utilization
Provider on this system to version
A.01.06.00.00 or later.
If you prefer not to use the method
described in the message, change the See message text. The Name Resolution Service could not
resolve localhost on the CMS. To
value for the CMS_HOSTNAME property correct this, make sure that either the
in the vseprefs.props file from name localhost can be resolved on
localhost to some other name that
resolves to the IP address of the CMS.
the CMS or change the
CMS_HOSTNAME setting in
/etc/opt/vse/vseprefs.props
to
a hostname for the CMS that can be
resolved. See the hosts(4) and
nsswitch.conf(4) manual pages.
See message text. If HP SIM has not correctly
discovered all of the system The system attribute "attribute-name"
is not available from HP SIM for the
attributes (operating system type, workload-name workload. Either run
model, CPU count/speed, and "Identify" on the system in HP SIM and
memory size) some of the attributes export the profile again, or correct these
needed to export the profile using fields in the header of the exported profile
before importing it.
the capprofile command are
not available.
If the profile data originated from a
capprofile
export, re-export the data
When importing a file using
capprofile
, the input file header
The system attribute "attribute-name"
must be specified before this profile can
be imported.
after running Options →Identify must contain correct values for the
Systems...on the system in HP SIM, or system from which the profile data
manually correct the values in the was gathered. If one or more
header. See the capprofile(1M) attributes have the value
command reference page for an
example of a correctly formatted file. , the profile cannot be
imported.
Install the HP VM WBEM provider
(vmProvider) on the virtual machine or
correct the configuration problem.
For help with using vseassist, see
the HP Matrix Operating Environment
Getting Started Guide. An HP virtual machine may be
discovered by HP SIM and labeled
as a standalone server if the
system does not have a properly
configured WBEM provider for HP
VMs. Such a system cannot be
collected from until it is discovered
by HP SIM correctly. The system "system_name" has no
workload defined. Make sure to select
Tools
→VSE Management...in HP SIM
before running this command for the first
time. For HPVM Guests, please be sure
that the HPVM WBEM provider is properly
configured. If problems persist, run
vseassist
to further diagnose errors.
170 Capacity Advisor messages