FUTEK IPM600 (D610) Digital Display - Manual (Page 5)

FCC COMPLIANCE STATEMENT FOR AMERICAN USERS
FCC COMPLIANCE STATEMENT FOR AMERICAN USERS
This device complies with Part 15 of the FCC Rules. Operation is subject to
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested an found to comply with the limits for a
Class A Digital Device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable Protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures:
- - Reorient or relocate the receiving antenna.
- - Increase the separation between the equipment and receiver.
- - Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- - Consult the dealer or an experienced radio / TV technician for help.
WARNING
This equipment has been verified to comply with the limits for a Class A personal
digital device, pursuant to subpart B of Part 15 of FCC Rules. Only peripherals
(computer input / output devices, terminals, printers, etc.) certified or verified to
comply with the Class A or B limits may be attached to this equipment. Operation
with non-certified or non-verified personal computer and / or peripherals is likely to
result in interference to radio and TV reception. The connection of a non-shielded
equipment interface cable to this equipment will invalidate the FCC Certification of
this device and may cause interference levels which exceed the limits established
by the FCC for this equipment.
You are cautioned that changes or modifications not expressly approved by the
party responsible for compliance could void your authority to operate the
equipment.