FUTEK LSB Series User Manual

FUTEK Sensors

This drawing is submitted solely for the information and

exclusive use of the original addressee. It is not to be divulged

in whole or in part, by any firm or individual without written

permission from FUTEK

Drawing Number: F3171-01

CAUTIONS

MOUNTING

TENSION LOADING MUST BE

IN LINE WHEN COMPENSATING
LINKAGES ARE NOT USED

LOAD MUST BE FLAT

AND PARALLEL WHEN

COMPENSATING LINKAGES

ARE NOT USED

1) DO NOT PULL ON OR CARRY SENSOR BY CABLE.

2) ANY TAMPERING OR REMOVAL OF COVER, CABLE AND/
OR CONNECTOR WILL VOID WARRANTY.
3) ALWAYS HAVE SENSOR PLUGGED IN DURING
INSTALLATION TO MONITOR OUTPUT TO AVOID
PERMANENT ZERO SHIFT AND OVERLOAD.

THREAD THE FIXTURE TO
THE SENSOR. THREADING
THE SENSOR TO THE

FIXTURE CAN APPLY TORQUE

THAT MAY DAMAGE THE UNIT

SENSOR CAN BE USED SANDWICHED

WITH MORE THAN ONE UNIT BETWEEN
TWO PLATES

ROD END BEARINGS WITH CLEVISES OR ALIGNMENT
COUPLERS MAY BE USED TO MAKE UP FOR
MISALIGNMENT

SENSOR CAN BE

USED TO MONITOR

VOLUME IN A HOLDING
TANK APPLICATION

LOAD MUST BE IN LINE AND
CENTERED

CLEVIS

ROD END

BEARING

A LOAD BUTTON MAY BE USED
WHILE THE BOTTOM OF THE

SENSOR IS SECURED TO A BASE

PLATE

CYLINDRICAL S-BEAM

STANDARD S-BEAM

ALIGNMENT

COUPLERS

JUNIOR S-BEAM