Cautions and requests for use – FUTEK IPM600 (D610) Digital Display User Manual
Page 2

Cautions and Requests for Use
Cautions and Requests for Use
Do not disassemble the main body for modifications or repair.
Be sure to use crimp contacts for connection to terminal blocks, and do not to
connect bare wires as they are.
Be sure to ground the protective ground terminal.
- The main F.G. is indicated by
, it must be grounded with the protected
earth.
Be sure to disconnect the power cable when performing the following.
- Attachment/detachment of connectors of options.
- Wiring/connection of cables to terminal blocks.
- Connection of the ground line.
Be sure to assort the machine which is supplied by AC power through the ter-
minal in a panel with lock or screws.
Carefully check wiring, etc. before applying power.
Take an interval of more than 5 seconds when repeating ON/OFF.
Take adequate shielding measures when using at the following locations.
- Near a power line.
- Where a strong electric field or magnetic field is formed.
- Where static electricity, relay noise or the like is generated.
Do not install in the following environments.
- Place
exposed to direct sunlight.
- Where the temperature and/or humidity exceeds the range in the
specifications.
- Place
containing corrosive gas or flammable gas.
- Place
with large quantities of dust, salt or iron powder.
- Where the product may be splashed with water, oil or chemicals.
- Where the main body is directly affected by vibration or shock.
Set the correct Excitation Voltage for the sensor.
2.5V is set when F371 is
dispatched from us.