FUTEK IPM600 (D610) Digital Display - Manual (Page 20)

3.CONNECTION
9
3. CONNECTION
3-1. Power Input Connection
AC spec.
Connect AC power code. The input voltage is 100V-240V AC.
The frequency is 50/60Hz.
DC spec.(Depending on the request at the time of order)
Connect the positive (+) side of the power source to the red screw side of the terminal
block on the back of the F371, and its negative (-) side to the black screw side. The input
voltage is 12V-24V DC.
Black
White)
Green)
AC IN
L
N
F.G.
CAUTION
Pay close attention to the wring in case of power on.
Red
Black)
DC IN
F.G.
CAUTION
Be aware that the voltage drops depending on the wire thickness
and length. Also, never input an AC power source. Doing so will
cause a failure.