GW Instek GDM-8200A User Manual - Manual (Page 97)

REMOTE CONTROL
97
5. Press the ENTER key to
confirm USB selection.
6. Press the Exit key to go back
to the default display.
7. Connect the USB cable to the
rear panel terminal (upper
port). CAL
KEY
Configure RS-232C interface
Configuration step
1. Press the Shift key, the 2ND
(Menu) key, the Right key
twice. The I/O configuration
menu appears.
2. Press the Down key, then the
Right key. The RS-232C
selection display appears.
3. Press Enter or Down to confirm
RS232 selection.
or
4. Press the Down or UP keys
repeatedly to select the baud
rate.
1152005760038400192009600
5. Press the ENTER key to
confirm RS-232C and baud
rate selection.