GW Instek GDM-8200A User Manual - Manual (Page 105)

REMOTE CONTROL
105
trac:cle Clears buffer contents.
SYStem related command
syst:disp Turns display On or Off.
Parameter: Boolean
Example: disp_1 (display On)
syst:disp? Returns display status, On of Off.
Parameter: Boolean
syst:beep:stat Select beep mode.
Parameter: 0 (Off), 1 (Pass), 2 (Fail)
Example: syst:beep:stat_1 (Beep when pass)
syst:beep:stat? Returns beep mode status.
Parameter: No beep, Beep on Pass, Beep on Fail
syst:err? Returns current system error, if there is any.
syst:vers? Returns system version.
Parameter: 1.00 ~
*rst Reset system.
*idn? Returns company name, model No., and system version.
Example: GW, GDM8255A, 1.0
STAtus reporting command
stat:ques:enab Enable bits in the Questionable Data register.
stat:ques:enab? Returns Questionable Data register contents in decimal
number.
stat:ques:even? Returns Questionable Data event register contents in decimal
number.
stat:pres Clear Questionable Data enable register.
RS-232C interface command
syst:loc Enables front panel control and disables remote control
syst:rem Enables remote control and disables front panel control
IEEE 488.2 common command
*cls Clears event status register (Output Queue, Operation Event
Status, Questionable Event Status, Standard Event Status)
*ese? Returns ESER (Event Status Enable Register) contents.
Example: 130 means ESER=10000010