GW Instek APS-1102 Control Software User Manual - Manual (Page 53)

APS-1102A Control Software User Manual
40
Logging Interval
Specifies the interval of measurements logging in seconds. The range of the value is between 1 to 300.
 The accuracy of the logging interval is not guaranteed.
6.4 Log Display Section
When the logging is started, a log for each line is created in the log display section with the specified
interval.
6.5 Measurements Log File
When the [Save in a File] check box is selected in the [Logging Setting] dialog ( 6.3.4), starting a
logging creates a measurements log file in the folder specified in [Location] and appends a log to the
log file.
The format of the measurements log file is described below.
File name
The file is created with the name of YYYYMMDD_HH_MM_SS.txt based on the time when the
logging is started.
File format
Text file delimited by comma. The first line includes the item names and the subsequent lines represent
measurements logs.
 Data in the log display section cannot be copied to the clip board or saved to a file. If you need to
keep the log in a file, select the [Save in a File] check box in the [Logging Setting] dialog
( 6.3.4) and use the measurements log file.
 Logging data displayed on a window or saved in a file is up to 3600 lines. If logging data exceeds
3600 lines, displayed data will be wrapped around and a new file will be created. Excess data will
be saved in the new file.
 Logging may stop if there is not enough empty space in the hard disc.
 Logging cannot be done during sequence execution.
CAUTION
CAUTION