GW Instek APS-1102 Control Software User Manual - Manual (Page 42)

5 Sequence
29
Add Step
Adds a new step after the last step (line). Following three methods are available.
 From the Menu Bar, select [Edit] - [Add Step].
 On the keyboard, press Alt, E, S.
 Click [Add Step] button of the step arrangement.
Insert Step
Adds a new step just above the current cursor step (line). Following three methods are available.
 From the Menu Bar, select [Edit] - [Insert Step].
 On the keyboard, press Alt, E, I.
 Click [Insert Step] button of the step arrangement.
Delete Step
Deletes the current cursor step (line). Following three methods are available.
 From the Menu Bar, select [Edit] - [Delete Step].
 On the keyboard, press Alt, E, E.
 Click [Delete Step] button of the step arrangement.
Go Up
Exchanges the current cursor step (line) with the step above it. Following three methods are available.
 From the Menu Bar, select [Edit] - [Go Up].
 On the keyboard, press Alt, E, U.
 Click [] button of the step arrangement.
Go Down
Exchanges the current cursor step (line) with the step below it. Following three methods are available.
 From the Menu Bar, select [Edit] - [Go Down].
 On the keyboard, press Alt, E, D.
 Click [] button of the step arrangement.
Copy
Copies the setting data in the selected line range or cell range to the Clip Board. Following three
methods are available.
 From the Menu Bar, select [Edit] - [Copy].
 On the keyboard, press Alt, E, C.
 On the keyboard, press Ctrl + C.