GW Instek APS-1102 Control Software User Manual - Manual (Page 39)

APS-1102A Control Software User Manual
26
5.2 Operations on Each Section
5.2.1 Menu Bar
Creates a new sequence setting file
Opens the sequence setting file
Overwrites and saves the sequence setting file
Saves the sequence setting file using a new name
Exits the software
Copies the selected parameter
Pastes the copied parameter
Makes all the parameters to selected status
Initializes the selected parameter
Adds a step
Inserts a step just above the selected step
Deletes the selected step
Exchanges the selected step with the step above it
Exchanges the selected step with the step below it
Starts a sequence execution
Stops the sequence execution
Pauses the sequence execution
Goes to the step set on the branch 0
Goes to the step set on the branch 1
Turns on the output of EC power source
Turns off the output of ECpower source
Switches between the Control Mode and the Edit Mode of
this software
Edit(E)
Control(R)
New(N) Ctrl+N
Open(O)... Ctrl+O
Save(S) Ctrl+S
Save As(A)...
Exit(X)
Copy(C) Ctrl+C
Paste(P) Ctrl+V
Select All(L) Ctrl+A
Initialize(A) Ctrl+I
Add Step(S)
Insert Step(I)
Delete Step(E)
Go Up(U)
Go Down(D)
Start(S)
Stop(E)
Hold(H)
Branch 0
Branch 1
Output ON(N)
Output OFF(F)
Switch Mode
File(F)
Figure 5-2 Sequence Window Menus