GW Instek APS-1102 Control Software User Manual - Manual (Page 36)

4 Basic Controller
23
4.6 Logging
Open the [Logging] window ( 6). Following two methods are available.
 From the Menu Bar, click [Tool] - [Logging].
 On the Tool Bar, click the [Logging] icon (
4.2.2).
4.7 Arbitrary Waveform Editing
Show the Arbitrary waveform editing tool ( 7). Following two methods are available.
 From the Menu Bar, click [Tool] - [Edit Waveform].
 On the Tool Bar, click the [Arbitrary Waveform Editing] icon (
4.2.2).
4.8 Restrictions in the Communication Offline State
In the Basic controller, when you perform an operation that needs communication (e.g., clicking Set,
Reload, or OUTPUT), communication with the connected APS power source is attempted. When the
communication is established, the software inquires the APS power source about the settings, and
updates each setting values in the window.
In the communication offline state, each setting value cannot be obtained from the APS power source.
So, when an operation requiring the communication like shown above was performed, each setting
value in the window is populated with the default value held by the software.