GW Instek APS-1102 Control Software User Manual - Manual (Page 47)

APS-1102A Control Software User Manual
34
5.4 Control
This section describes how to control a start, stop, etc. of the sequence.
5.4.1 Start
Enabled only in the execution mode and with the output on. Following three methods are available.
 From the Menu Bar, select [Control] - [Start].
 On the keyboard, press Alt, R, S.
 In the Operation Bar, click [Start] button (
5.2.7).
5.4.2 Stop
Following three methods are available.
 From the Menu Bar, select [Control] - [Stop].
 On the keyboard, press Alt, R, E.
 In the Operation Bar, click [Stop] button (
5.2.7).
5.4.3 Hold
Following three methods are available.
 From the Menu Bar, select [Control] - [Hold].
 On the keyboard, press Alt, R, H.
 In the Operation Bar, click [Hold] button (
5.2.7).
5.4.4 Branch
Describes the branch 0. The branch 1 is similar to the branch 0. Following two methods are available.
 From the Menu Bar, select [Control] - [Branch 0].
 In the Operation Bar, click [Branch 0] button (
5.2.7).