Sequence setting file, Save as, Save – GW Instek APS-1102 Control Software User Manual User Manual
Page 46: File reading, 3 sequence setting file
5 Sequence
33
5.3
Sequence Setting File
There are the following type of file format for the sequence data used by the Control Software for APS
Series:
Sequence setting file (extension is .sqd)
This file can be read and saved by Control Software for APS Series.
About compatibility with "APS-1102 control software" accompanying with APS-1102:
Sequence setting file (*.dat) created with the "APS-1102 control software" cannot be used with this
software.
Sequence setting file created with this software cannot be used with the "APS-1102 control
software".
5.3.1 Save As
Saves the sequence setting file as a new file. The [Save As] dialog can be opened by any of the
following two methods. For newly created data, the Save operation works as "Save As."
From the Menu Bar, select [File] - [Save As].
On the keyboard, press Alt, F, A.
5.3.2 Save
Overwrites and saves to the existing sequence setting file. Following four methods are available. For
newly created data, the Save operation works as "Save As."
From the Menu Bar, select [File] - [Save].
On the keyboard, press Alt, F, S.
On the keyboard, press Ctrl + S.
On the Tool Bar, click the [Save] icon (
5.3.3 File Reading
Opens the sequence setting file. The Open File dialog can be opened by any of the following three
methods.
From the Menu Bar, select [File] - [Open].
On the keyboard, press Alt, F, O.
On the keyboard, press Ctrl + O.
On the Tool Bar, click the [Open] icon (
CAUTION